Bushnell Telescope 78 9003 User Manual

DEEP SPACE SERIES  
525X3” REFLECTOR  
MODEL 78-9003  
1
17  
16  
15  
14  
2
3
13  
4
5
12  
11  
6
10  
8
9
7
1. Finderscope  
9. Accessory Tray  
2. Rack & Pinion Focusing Mechanism  
3. .965" Format Eyepiece  
4. Vertical Stabilizer Bar  
5. Azimuth Lock Screw  
6. Tripod Leg  
10. Tripod Leg Lock Screws  
11. Stablizer Bar Mounting Screw  
12. Alt-Azimuth Yoke Mount  
13. Primary Mirror (Internal)  
14. Main Telescope Tube  
7. Tripod Leg Middle Section  
8. Accessory Tray Brace  
15. Vertical Fine Adjustment Screw  
16. Finderscope Focus Adjustment  
17. Finderscope Adjustment Screws(3)  
 
HOW TO USE YOUR NEW TELESCOPE  
Astronomical telescopes are designed such that the image you see will appear  
UPSIDE DOWN and REVERSED, this is acceptable for viewing celestial bodies.  
Selecting an Ocular Lens:  
1. You should always start viewing with the lowest power eyepiece, which in this case is the 20 mm lens. Note:  
the base power of each ocular lens is determined by the focal length of the telescope objective lens, which for  
this model is 700 mm. A formula can be used to determine the power of each eyepiece: Telescope  
OBJECTIVE lens (Primary Mirror) focal length EYEPIECE focal length = MAGNIFICATION (e.g. Using  
the 20 mm lens, the calculation would look like this: 700 mm ¸ 20mm = 35x or 35 power.)  
Focusing Telescope:  
1. After selecting the desired Eyepiece (3), aim Main Telescope Tube (14) at a land-based target at least 200  
yards away (e.g. A telephone pole or building). Fully extend focusing tube by turning Rack and Pinion  
Focusing Mechanism (2).  
2. While looking through selected Eyepiece (3) (in this case the 20 mm), slowly retract focusing tube by turning  
Rack and Pinion Focusing Mechanism (2) until object comes into focus.  
Aligning Finderscope:  
1. Look through Main Telescope Tube (14) and establish a well-defined target. (see focusing telescope section)  
tighten the Stabilizer Bar Mounting Screw (11) and Azimuth Lock Screw (5) so that telescope’s aim is not  
disturbed.  
2. Looking through finderscope, alternate tightening each Finderscope Adjustment Screw until crosshairs of  
finderscope are precisely centered on the same object already centered in main telescope tube's field of view.  
3. Now, objects located first with the Finderscope (1) will also be centered in the field of view of the Main  
Telescope Tube (14).  
Never Look Directly At The Sun With Your Telescope  
Permanent Damage To Your Eyes May Result.  
Enjoying Your New Telescope  
1. First determine your targeted object. Any bright object in the night sky is a good starting point. One of the  
favorite starting points in astronomy is the moon. This is an object sure to please any budding astronomer or  
experienced veteran. When you have developed proficiency at this level, other objects become good targets.  
Saturn, Mars, Jupiter, and Venus are good second steps to take.  
2. The first thing you need to do after assembling the telescope as planned is center the desired object in the  
finderscope cross hairs. Provided you did a reasonable job aligning the finderscope, a quick look through the  
main telescope tube at low power should reveal the same image. With the lowest power eyepiece (the one  
with the largest number printed on it) you should be able to focus the same image that you saw through the  
finderscope. Avoid the temptation to move directly to the highest power. The low power eyepiece will give  
you a wider field of view, and brighter image--thus making it very easy to find your target object. At this point  
with a focused image in both scopes, you've passed the first obstacle. If you don't see an image after  
attempting to focus it in, you might consider aligning your finderscope again. Once you pass this step, you'll  
will enjoy the time spent ensuring a good alignment. Every object you center in the finderscope will be easily  
found in the main telescope tube, which is important for continuing your exploration of the night sky.  
 
3. The low power eyepieces are perfect for viewing the full moon, planets, star clusters, nebulae, and even  
constellations. These should build your foundation. However, for more detail, try bumping up in magnification  
to higher power eyepieces on some of these objects. During calm and crisp nights, the light/dark separation  
line on the moon (called the "Terminator") is marvelous at high power. You can see mountains, ridges and  
craters jump out at you due to the highlights. Similarly, you can move up to higher magnifications on the  
planets and nebulae. Star clusters and stars are best viewed through the low power no matter what.  
4. The recurring astronomical theater we call the night sky is an ever-changing billboard. In other words, not the  
same movie plays all the time. Rather, the positions of the stars change not only hourly as they seem to rise  
and set, but also throughout the year. As the earth orbits the sun our perspective on the stars changes on a  
yearly cycle about that orbit. The reason the sky seems to move daily just as the sun and the moon "move"  
across our sky, is that the earth is rotating about its axis. As a result you may notice that after a few minutes  
or a few seconds depending on what power you are viewing at, the objects in your telescope will move. At  
higher magnifications especially, you will notice that the moon or Jupiter will "race" right out of the field of  
view. To compensate, just move the fine adjustment controls on your telescope to "track" it in the necessary  
path.  
Helpful Hints  
1. Your telescope is a very sensitive instrument. For best results and fewer vibrations set your telescope up on  
a level location on the ground rather than your concrete driveway or your wooden deck. This will provide a  
more stable foundation for viewing, especially if you've drawn a crowd with your new telescope.  
2. If possible view from a location that has relatively few lights. This will allow you to see much fainter objects.  
You'd be surprised how much more you'll see from your local lake or park when compared to a backyard in  
the city.  
3. Using your telescope out a window is NEVER recommended.  
4. View objects that are high in the sky if possible. Waiting until the object rises well above the horizon will  
provide a brighter and crisper image. Objects on the horizon are viewed through several layers of earth's  
atmosphere. Ever wonder why the moon appears orange as it sets on the horizon. It's because you are  
looking through a considerable more amount of atmosphere than you would directly overhead. (Note: If  
objects high in the sky are distorted or wavy, you are probably viewing on a very humid night.) During nights  
of unstable atmosphere, viewing through a telescope can be frustrating if not impossible. Astronomers refer  
to crisp, clear nights as nights of "good seeing."  
Where do I start?  
Your Bushnell telescope can bring the wonders of the universe to your eye. While this manual is intended to  
assist you in the set-up and basic use of this instrument, it does not cover everything you might like to know about  
astronomy. The first thing you need to do is get a very simple star chart and a flashlight with a red bulb or red  
cellophane over the end. For objects other than stars and constellations, a basic guide to astronomy is a must.  
Some recommended sources appear on our website at www.bushnell.com. Also on our website will be current  
events in the sky for suggested viewing. But, some of the standbys that you can see are:  
The Moon--a wonderful view of our lunar neighbor can be enjoyed with any magnification. Try viewing at different  
phases of the moon. Lunar highlands, lunar Maria (lowlands called "seas" for their dark coloration), craters,  
ridges and mountains will astound you.  
Saturn--even at the lowest power you should be able to see Saturn's rings and moons. This is one of the most  
satisfying objects in the sky to see simply because it looks like it does in pictures. Imagine seeing what you've  
seen in textbooks or NASA images from your backyard!  
Jupiter--the largest planet in our solar system is spectacular. Most noted features are its dark stripes or bands  
both above and below its equator. These are the north and south equatorial belts. Also interesting are Jupiter's  
four major moons. Pay close attention to their positions from night to night. They appear to be lined up on either  
side of Jupiter.  
 
Mars--The Great Red Planet appears as a reddish-orange disk. Look at different times of the year and try to  
catch a glimpse of the white polar ice caps.  
Venus--just like the moon, Venus changed phases from month to month. Some views of brilliant Venus appear  
as if you were looking at a distant crescent moon.  
Nebulae--The Great Orion Nebula is a very well known night sky object. This and many others are brought to you  
by this telescope.  
Star Clusters--View millions of stars densely packed in a cluster that resembles a ball.  
Galaxies--One of the greatest and most interesting galaxies is our neighbor the Andromeda Galaxy. Enjoy this  
and many others. Much, much, more!  
ANSWERS TO COMMONLY ASKED QUESTIONS  
1. The image I see in the telescope is upside down  
and reversed from right to left ?  
·
An upside-down and reversed image is a  
common characteristic of most astronomical  
telescopes. Since telescopes are used for  
astronomical viewing orientation is not important.  
The image in the finderscope will also be upside  
down and reversed.  
2. How do I determine the power my telescope ?  
3. Where do I find the Telescope Focal Length  
·
·
The power of your telescope can be determined  
by dividing the focal length of the objective lens  
by the focal length of the eyepiece. The  
eyepiece focal length is the number printed on  
the eyepiece. (For example: 700 ¸ 20 = 35X)  
The telescope focal length is the same focal  
length as the objective focal length. For this  
telescope it is 700mm. Telescope focal lengths  
range from 600mm to 900mm on Bausch &  
Lomb, Bushnell and Jason telescopes.  
4. What can I see with my telescope ?  
·
·
Telescopes with power ranging from 25X to 50X  
can be used to view Star Clusters and Nebulae.  
90X to 120X telescope can view galaxies. Most  
planets can be seen at 150X and higher.  
5. What do the numbers on the eyepiece mean ?  
The numbers on the eyepiece represents the  
“focal Length” of the eyepiece.  
TROUBLESHOOTING GUIDE  
If after you have set-up your new telescope you are unable to see any objects, use this Quick  
Reference guide to help you to understand the cause of the problem and quickly determine a remedy  
1. I’ve completed the set-up yet I can’t see anything  
·
Check to see if objective lens cover has been  
removed.  
·
Try to view an object that is 200 or more yards  
 
away.  
·
·
If there is more than one eyepiece included with  
the telescope, use the lowest power (highest  
number) eyepiece to begin viewing.  
Use the Rack & Pinion Focusing Mechanism  
(3) to bring the object you are trying to view into  
focus  
Telescope LIFETIME LIMITED WARRANTY  
Your telescope is warranted to be free of defects in materials and workmanship for the lifetime  
of the original owner. The Lifetime Limited Warranty is an expression of our confidence in the  
materials and mechanical workmanship of our products and is your assurance of a lifetime of  
dependable service.  
If your telescope contains electrical components the electronic components are warranted to be  
free of defects in materials and workmanship for one year after the date of purchase.  
In the event of a defect under this warranty, we will, at our option, repair or replace the  
product, provided that you return the product postage prepaid. This warranty does not cover  
damages caused by misuse or improper handling, installation or maintenance of the product.  
Any return made under this warranty must be accompanied by the items listed below:  
1) A check in the amount of $15.00 to cover the cost of handling  
2) Name and address for product return  
3) An explanation of the defect  
4) Product should be well packed in a sturdy outside shipping carton to prevent  
damage in transit and return postage prepaid to the address listed below:  
IN U.S.A. Send To:  
Bushnell * 8500 Marshall Drive * Lenexa, Kansas 66214  
IN CANADA Send To:  
Bushnell * 25A East Pearce Street, Unit 1 * Richmond Hill, Ontario L4B 2M9  
For products purchased outside the United States and Canada please contact your local dealer  
for applicable warranty information. This warranty gives you specific legal rights. You may  
have other rights which vary from country to country.  
©2001 Bushnell Performance Optics  
 

Black Decker Trimmer LST220 User Manual
Blomberg Oven BEO 5422 User Manual
Blomberg Refrigerator KQD 1360X User Manual
Bosch Power Tools Laser Level GLL2 10 User Manual
Breville Fryer BDF300 User Manual
Casio Digital Camera K831PSM2DMX User Manual
Casio Watch MA0307 EA User Manual
Changhong Electric Flat Panel Television W260F8U, W320F8U, W370F8U User Manual
Char Broil Gas Grill 466270611 User Manual
Cisco Systems MP3 Player OL 13985 01 User Manual