Chamberlain Universal Remote 973TB User Manual

Security® 3-Button Remote Control  
OWNER’S MANUAL  
Models: 973TB • 973TS • 973TC • 973TT  
The 900 Series remote control works only with door openers and  
light controls having an orange “Learn” button.  
WARNING  
Programming instructions are described and illustrated below.  
The additional push buttons can also activate other garage door  
openers and/or light controls. (Instructions for programming light  
products are included with those accessories.)  
To prevent possible SERIOUS INJURY or DEATH from a moving gate  
or garage door:  
• ALWAYS keep remote controls out of reach of children. NEVER  
permit children to operate, or play with remote control transmitters.  
• Activate gate or door ONLY when it can be seen clearly, is properly  
adjusted, and there are no obstructions to door travel.  
Instructions are Described and Illustrated Below  
• ALWAYS keep gate or garage door in sight until completely closed.  
NEVER permit anyone to cross path of moving gate or door.  
9
1
9
1
7
3
7
3
5
5
KG  
OR  
Open/Close/Stop Operation  
1
2
3
Your Security® remote control can be programmed to operate  
one door using all 3 buttons: the large button will only open the  
door, the middle button will close the door, and the third button  
will stop the door’s movement. You may set up this feature as  
follows:  
9
1
9
1
7
3
7
5
5
KG  
KG  
1
2
1. With the door closed, press and hold the  
large remote push button.  
Open  
Close  
Stop  
2. Press and hold the Lock button on the  
door control.  
3. Press and hold the door control push bar.  
1. Press and release the “learn” button on  
the motor unit. The learn indicator light  
will glow steadily for 30 seconds.  
When the opener lights flash, release all buttons. Test by pressing  
the large (Open) button on the remote. The door should open.  
Press it again while the door is open and nothing should happen.  
Press the middle (Close) button while the door is moving and it  
should close. Press the third (Stop) button and the door should  
stop immediately.  
2. Within 30 seconds, press and hold the  
button on the hand-held remote.  
3. Release the button when the motor unit light  
blinks. It has learned the code. If light bulbs are  
not installed, two clicks will be heard.  
The Remote Control Batteries  
WARNING  
To prevent possible SERIOUS INJURY or DEATH:  
• NEVER allow small children near batteries.  
• If battery is swallowed, immediately notify doctor.  
To Erase All Codes From Motor Unit Memory  
To deactivate any unwanted remote, first erase all codes.  
Press and hold the “learn” button on motor unit  
until the learn indicator light goes out  
(approximately 6 seconds). All previous codes  
are now erased. Reprogram each remote or  
keyless entry you wish to use.  
The lithium batteries should produce  
power for up to 5 years. To replace,  
pry open case with visor clip or  
screwdriver, as shown. Insert  
Battery  
positive  
side up (+)  
batteries positive side up (+).  
To Control the Opener Lights  
Dispose of old batteries properly.  
With Security® transmitters, a remote push button can be  
programmed to operate the opener lights without opening the  
door.  
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this  
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the  
battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.  
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the  
following two conditions: (1) this device may not cause harmful interference, and (2) this device must  
accept any interference received, including interference that may cause undesired operation.  
1. With the door closed, press and hold the remote button that  
you want to control the light.  
2. Press and hold the Light button on the door control.  
3. Press and hold the Lock button on the door control.  
4. After the opener lights flash, release all buttons.  
Test by pressing the remote push button. The opener lights  
should turn on or off but the door should not move.  
Replacement Parts  
3V2032 Lithium battery: . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20  
Visor clip: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137  
Owner’s manual - Spanish: . . . . . . . . . . . . . . . . . . .114A2738SP  
FOR SERVICE DIAL OUR TOLL FREE NUMBER:  
1-800-528-2817  
© 2004, Chamberlain Group Inc.  
All Rights Reserved  
114A2738B  
Printed in Mexico  
 

Best Ventilation Hood K260A series User Manual
Black Decker Mixer MGD200 User Manual
Blue Rhino Outdoor Fireplace WAD517A User Manual
Bosch Appliances Medical Alarms VJR A3 SP User Manual
Braun Blender MR 5550 M FP User Manual
Briggs Stratton Air Cleaner 12L800 User Manual
Califone Fish Finder 1216 USB User Manual
Century Baby Carrier ISPP016AB 04 03 User Manual
Chicago Electric Marine Instruments 93801 User Manual
Cisco Systems Network Card FE 511 K9 User Manual